Post your Desktop setup


#61

Even with the little feet out I find it too flat.
The bottom back of the board is ~4cm elevated.


(Yes,) #62

updated a little bit/also cleaned
image


(Yes,) #63

just realized that I haven’t done a full setup pic in … a while, just photos of either side of it lol.
image
image
image
rig itself didnt change much from above pic so.


(Yes,) #64

cleaned, also broke out the Model F again because reasons.
IMG_20190206_125659


#65

I’M SORRY I CAN’T HEAR YOU?


(Yes,) #66

lol

(Jesse) #67

Surprised @Dynamic_Gravity hasnt posted his setup here, it changes every other month kek


#68

Might as well post it here too, my network/server setup after the maintainace.

IMG_20190208_192615

And not terrible cable management too XD

IMG_20190208_192626


#69

Does your Ubiquiti AP also get hot in one spot on the back?


On topic: the monitor update. Only need to swap the DVI-D cable for the HDMI cable that’s on its way.

IMG_20190211_102920703


#70

Yep iirc that is where the SoC is on the unit and its normal for them to run quite hot so i wouldn’t worry about it too much.


(Jesse) #71

I don’t think my neckbeard nest would fit this category, I guess it gives me a reason to clean my room though.


#72

We don’t mind mess, can’t be much worse than some of ours anyway XD